Mechanical Specifications; Power Supply Specifications - HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual

Table of Contents

change may be limited by the type and number of options installed.

System performance during standard operating support might be reduced if operating above 30°C (86°F).

Extended ambient operating support

For approved hardware configurations, the supported system inlet range is extended to be: 5° to 10°C (41° to 50°F) and 35° to 40°C (95°

to 104°F) at sea level with an altitude derating of 1.0°C per every 175 m (1.8°F per every 574 ft) above 900 m (2,953 ft) to a maximum of

3050 m (10,000 ft).

40°C to 45°C (104°F to 113°F) at sea level with an altitude derating of 1.0°C per every 125 m (1.8°F per every 410 ft) above 900 m (2953

ft) to a maximum of 3,050 m (10,000 ft).

The approved hardware configurations for this system are listed on the Hewlett Packard Enterprise

Mechanical specifications

Specification

Value

Dimensions

Height

Depth

Width

Weight, approximate values —

Weight, approximate values

Minimum

Maximum

Depending on the installed options and the regional location where the server was purchased, the server can be configured with one of the

following power supplies. For detailed power supply specifications, see the QuickSpecs on the Hewlett Packard Enterprise

Subtopics

HPE 350 W Gold Non-hot-plug Power Supply (92% efficiency)

HPE 350 W Platinum Non-hot-plug Power Supply (94% efficiency)

HPE 500 W Flex Slot Platinum Hot-plug Low Halogen Power Supply

HPE 800 W Flex Slot Titanium Hot-plug Low Halogen Power Supply

HPE 350 W Gold Non-hot-plug Power Supply (92% efficiency)

—

36.83 cm (14.50 in)

47.50 cm (18.70 in)

17.53 cm (6.90 in)

10.40 kg (22.93 lb)

19.00 kg (41.89 lb)

Hewlett Packard Enterprise website

HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide

website.

178

Table of Contents