HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 131

CAUTION: CAUTION:
The processor load plate and hinge lever should close without resistance. Forcing to close these parts can damage the The processor load plate and hinge lever should close without resistance. Forcing to close these parts can damage the
processor and the socket. This damage might require replacing the system board. processor and the socket. This damage might require replacing the system board.
7. Close the processor load plate (callout 1), and then engage the hinge lever (callout 2).
8. Apply new thermal grease to the processor in the pattern shown in the following image to ensure even distribution. Use the full contents
of the thermal grease syringe.
9. Install the heatsink:
CAUTION: CAUTION:
The heatsink fan does not have a fan guard. Special attention is needed when removing or installing the heatsink to
prevent finger injury.
CAUTION: CAUTION:
To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink contact surface,
hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 131