Removing And Replacing The System Fan - HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual

If the server is in rack mode, remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. Remove the air baffle .
8. If needed, disconnect any system cables that might be blocking access to the bottom side of the drive cage.
9. Disconnect the PCI fan cable .
10. Remove the PCI fan:
a. Remove the fan screws (callout 1).
b. Remove the fan from the chassis (callout 2).
Results Results
To replace the component, reverse the removal procedure.

Removing and replacing the system fan

Removing and replacing the system fan
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 69