HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 111

12. Remove the I/O cable:
a. Use a plastic spudger to pry both sides of the I/O assembly holder (callout 1), and then remove the holder from the I/O cable.
b. Remove the front I/O cable.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing the front USB cable Removing and replacing the front USB cable
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 111