Heatsink Replacement; Removing The Heatsink - HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual

Results Results
To replace the component, reverse the removal procedure.

Heatsink replacement

Heatsink replacement
Subtopics Subtopics

Removing the heatsink

Removing the heatsink
Installing the heatsink Installing the heatsink
Removing the heatsink Removing the heatsink
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
WARNING: WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system components to
cool before touching them.
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
v
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 73