Removing And Replacing The Front I/O Assembly - HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual

Removing and replacing the front I/O assembly

Removing and replacing the front I/O assembly
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a spudger or any small prying tool available.
About this task About this task
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. If installed, remove the air baffle .
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 109