HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 119

About this task About this task
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
If the server is in rack mode, remove the server from the rack .
5. Remove the access panel .
6. If installed, remove the air baffle .
7. Locate the battery on the system board .
8. If an expansion card installed on the expansion slot 2 blocks access to the system battery, remove the card.
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 119