Removing And Replacing The Power Distribution Board - HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual

a. Use a spudger to pry the blank from the chassis (callout 1).
b. Remove the blank (callout 2).
Results Results
To replace the component, reverse the removal procedure.

Removing and replacing the power distribution board

Removing and replacing the power distribution board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this task About this task
CAUTION: CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 116