Removing and replacing an M.2 SSD
Prerequisites
A No. 1 Phillips screwdriver is required to perform this procedure.
Procedure
1. Power down the server blade.
2. Remove the server blade.
3. Place the server blade on a flat, level work surface.
4. Remove the access panel.
5. Remove the left DIMM baffle.
6. Remove the screw with a No. 1 Phillips screwdriver, and then remove the M.2 SSD.
7. If necessary, repeat the M.2 SSD removal procedure for the second drive.
To replace the component, reverse the removal the procedure.
More information
Power down the server blade
Remove the server blade
Removing the access panel
Removing the DIMM baffles
Removing and replacing the direct connect SATA cable
Prerequisites
A T-15 Torx screwdriver is required to perform this procedure.
Removal and replacement procedures
57