HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 6

Removing and replacing an expansion card
Removing and replacing the energy pack
Removing and replacing the energy pack holder
Removing and replacing an M.2 SSD
Removing and replacing the iLO-M.2-serial module
M.2 SATA SSD replacement
Removing and replacing the M.2 SATA SSD add‑in card
Removing and replacing the M.2 SATA SSD on the add‑in card
HPE NS204i-p NVMe OS Boot Device replacement
Removing and replacing the boot device
Removing and replacing a boot device drive
Relocating the M.2 drive retaining latches
Removing and replacing an internal USB device
Removing and replacing the front I/O assembly
Removing and replacing the front USB cable
Removing and replacing the serial port cable
Removing and replacing the serial port blank
Removing and replacing the iLO dedicated network port blank
Removing and replacing the power distribution board
System battery replacement
System battery information
Removing and replacing the system battery
System board replacement
Removing the system board
Installing the system board
Re-entering the server serial number and product ID
Troubleshooting
NMI functionality
Troubleshooting resources
Configuration resources
Updating firmware or system ROM
Configuring the server
Configuring storage controllers
Deploying an OS
Configuring security
Optimizing the server
Server management
Managing Linux-based high performance compute clusters
Component identification
Front panel components
Front panel LED and button
Front panel LED power fault codes