HPE ProLiant ML30 Gen10 Plus Maintenance And Service Manual page 104

Retain these SSDs for installation onto the new boot device.
Results Results
To replace the component, reverse the removal procedure.
Removing and replacing a boot device Removing and replacing a
Prerequisites Prerequisites
Review the boot device drive bay LEDs to identify the failed drive.
About this task About this task
The boot device supports two physical drive sizes:
22110 (110 mm)
2280 (80 mm)
Two drives of the same physical size, or one of each size, can be installed at the same time. Depending on the replacement drive size, you
might need to relocate the M.2 drive retaining latches on the boot device.
CAUTION: CAUTION:
The boot device and the drives installed on the boot device are not hot-pluggable. To remove the boot device, or a drive
from the boot device, you must first power down the server.
CAUTION: CAUTION:
Before replacing a DIMM, backplane, expansion card, riser board, or other similar PCA components due to a perceived
hardware error, make sure first that the component is firmly seated in the slot.
When installing the replacement component:
Observe antistatic precautions.
Handle the PCA only along the edges.
Do not touch the components and connectors on the PCA.
Do not bend or flex the PCA.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
boot device drive drive
HPE ProLiant ML30 Gen10 Plus Server Maintenance and Service Guide 104