Working From The Schedule Tab - Ametek 5830 User Manual

Working From the Schedule Tab

Use the Schedule tab to schedule routine Zero.
Figure 3-11.
Schedule tab.
Verify Now Button
Abort Button
Abort button
Zero Now button
Adjust Offset check box
PN 583054901, Rev YA
Click to begin verify cycle now.
Click to terminate Verification or Zero.
Click to terminate Verification or Zero.
Click to begin Zero cycle now.
Checked
Check this box to adjust the span after a verify.
Not checked
Uncheck this box to verify without adjusting the span.
The 5830 will always adjust the offset after a zero cycle.
|
Controller/Interface 3-23