System Test - Ametek 5830 User Manual

System Test

Use the System Test key to perform tests on various components of the ana-
lyzer.
Figure 3-6.10.
System Test menu.
3-14 | 5830 Moisture Analyzer
Config
System Test
Test Display
Tests the display by providing a "checker board" pattern on the display.
Test Keypad
Tests the keypad by echoing characters to the display.
Test Alarms
Tests the alarm contacts by toggling them open / close.
Test Analog Output
Tests the Analog Output by allowing the user to set outputs to 4, 12, or
20 mA.
Test Serial Communications
Performs a "loop back" test and reports the result to the display.
Test
Start
Display
Cancel
Test
Press Key
Keypad
Open Contacts
Test Alarms
Close Contacts
4 mA Output
Test Analog
12 mA Output
Out
20 mA Output
Test Serial Start
Com
Cancel
PN 583054901, Rev YA