Working From the 5830 Configurator Software
The Configurator Software provides a graphical user interface to set up param-
eters for either a single analyzer or multiple analyzers.
Configurator Software Installation
1. Insert the Configurator Software CD into CD ROM drive.
2. The installation program should begin to run immediately. If it does not
3. Follow the instructions on the subsequent screens to complete the instal-
PN 583054901, Rev YA
Although you can set and view parameters for multiple analyzers
using the 5830 Configurator Software, you can only work with one
analyzer at any time.
start automatically, click RUN... from the Windows Start menu. Type the
drive letter, followed by a colon ( : ) and a backslash ( \ ) and the word
"setup.exe" (d:\setup.exe) and click OK to start the installation program.
lation. When you get to the Setup Complete screen, click Finish to com-
plete the installation. The default location for the 5830 software is in the
AMETEK, Inc. folder.
Turn off all power saving modes.
|
Controller/Interface
3-15