Figure 6-5.
Schedule tab.
Schedule Tab
Use the Schedule tab to schedule routine Zero.
Abort Button
Click to terminate verification or zero.
Verify Now Button
Click to begin verify cycle now.
Adjust Span check box
Checked
Not checked
Set Clock
(Time Synchronization) Click Set Clock to synchronize the clock within the
analyzer with the PC. The Time Synchronization box opens with the PC
time and date and the analyzer time and date. Click Synchronize to set the
time, or click Cancel to close the box.
Set Dryer Production Code
Click to enter the Dryer Production Code for the dryer that is installed in
the analyzer. Click OK to accept.
You must enter a new dryer code each time you replace the dryer.
NOTE
The analyzer performs a span adjustment at the end
of the verify cycle.
The analyzer verifies only.
Configurator Software Setup | 6-7