Working From The Run Mode Screen - Ametek ta7000 User Manual

Working From the Run Mode Screen

After the ta7000F has warmed up to normal operating temperature, press the
Run key to view the Main Menu screen. The upper-left corner of the screen
will display "Idle Mode" to indicate the ta7000F is not measuring or perform-
ing any other actions.
Figure 2-7.3.
Main Menu screen.
Next, to initiate automatic operation of the ta7000F, press the Run key again.
The upper-left corner of the screen will change to display "Run Mode" to indi-
cate the ta7000F is now performing a Cycle Run. "Idle" is now displayed in the
lower-left corner of the screen (see Figure 2-8.1).
Figure 2-8.1.
Run Mode screen.
The ta7000F will display the time left (in seconds) for the current cycle in the
Status Bar, next to Run Mode (see Figure 2-8.2). The results will be updated on
the screen as the concentration is determined.
PN T900-014, Rev B
Idle Mode
=
CH
4
=
CO
2
NHMC =
Run Cool Calib
Run Mode 235
Cycle Run
= 2.7
CH
4
= 6.1
CO
2
NHMC = 0.8
Idle
Installation and Start-Up
12:39:30
Page
Blank
12:55:30
Page
|
2-19