Special Addresses; Address $F0; Defined Commands (Master To Slave) - Ametek 5830 User Manual

Special Addresses

Addresses $F0 through $FF are reserved for special functions with address
$F0 used as a broadcast address.

Address $F0

Node address $F0 is used as a single point address (i.e., it is intended for use in
configurations with a single slave). The slave will respond to all messages with
node address $F0. You must be careful to prevent multiple slaves from receiv-
ing commands with the broadcast address as this will cause a bus contention.

Defined Commands (Master to Slave)

The commands that can be issued from the master are listed in Figure 2-20.
Figure 2-20.
Defined Commands table.
2-24 | 5830 Moisture Analyzer
Command Byte Function
A Echo
B Bad Command
C Acknowledge
F Read Data
G Not Used
H Write Data
L Write Cell EEPROM
Q Quit Zero
R Analyzer Reset
T Toggle Test Mode
Z Initiate Zero
PN 583054901, Rev YA