Table of Contents
Advertisement
Setting Up System Parameters
The configurator software provides a graphical user interface to set up your analyzer parameters.
Use the configurator software to set up your analyzer(s). While you can use the configurator
software to set up multiple analyzers, you can only view the status of a single analyzer at a
time. If using System 2000 Software, refer to the System 2000 manual.
PC Requirements for Configurator Software
• Windows 98, Windows 95 or Windows NT 4.0
• 640x480, 256-color display.
Configurator Software Installation
1. Insert the Setup Disk 1 in your floppy disk drive.
2. Choose RUN... from the Windows Start Menu.
3. Type the drive letter, followed by a colon ( : ) and a backslash ( \ ) and the word
"setup."
Example:
4. Follow the instructions on your screen. Click Next to continue the Setup process.
Configurator installation disk 2 may not be asked for depending on windows
version.
NOTE
Turn off all power saving modes.
NOTE
Configuring Your Device
This section provides instructions for setting up your 3050-AP Moisture Analyzer operating
parameters using the configurator software.
1. Define device and communication settings using the General Tab. Refer to fig-
ures 3.1 and 3.2.
Chapter 3
a:\setup
Parameter Setup
3-1
Advertisement
Table of Contents
