Two-Knife Booklet Trimmer-B1; Pre-Checks; Unpacking Procedure - Canon imagePRESS Lite C270 Installation Manual

Two-Knife Booklet Trimmer-B1

Pre-checks

■ Selecting Installation Site
To confirm the space required for the maintenance operation, refer to the installation manual "Checking the installation space".
• Safety Precautions > Points to Note at Installation > Checking Installation Space
CAUTION:
For emergency shutdown, be sure to secure 1,000 mm or more space on the sides and rear of the host machine.
CAUTION:
Install the Finisher, the Booklet Trimmer and the Two-Knife Booklet Trimmer on a floor which is flat and level. If the floor is
uneven or not level, this can cause sheet transport problems.
■ Points to Note at Installation
• An optional power cord is required to install this equipment.
• When installing the this equipment, the optional Two-Knife Booklet Trimmer Conveyer is required.
• For the procedure for installing the conveyer, refer to steps 3 to 5 of "Installation After Check/Adjustment".
NOTE:
The pictures and illustrations used may differ from the actual one, but the procedures are the same.
■ Check Required to use with the Fore-edge Booklet Trimmer
Check that software of the following machines support two-knife booklet trimmer-A1.
• Printer
• Finisher
• Fore-edge Booklet Trimmer
If the combination of software version is not correct, all the machines cannot be booted correctly.
■ Points to Note When Moving This Equipment
When moving this equipment after having unpacked it, be careful by placing a plate, etc. on areas with steps to prevent the casters
from hitting those steps.
If the casters hit a step, the casters or the base plate may be deformed.

Unpacking Procedure

NOTE:
When the machine is shipped, it is held in place by tapes and paddings to protect against vibration and shocks during shipment.
Remove all tapes and paddings before installing the machine. Save the removed paddings in case you need to use them again
to transport this equipment for relocation or repair.
CAUTION:
When you unpack the machine, you need to lift the cardboard box up to remove it. Therefore, unpack the machine at the
place where the height of the ceiling is higher than 2.7 m (106"). Check the unpacking location.
CAUTION:
this equipment weighs about 145 kg (319 lb). Be very careful when you move this equipment.
894
6. Paper Output Options