Table of Contents
Advertisement
NOTE:
Even if the above adjustment is performed, if a fixed skew or image shift occurs, the image is manually adjusted according to the
state of the printed image
• Adjustment of leading edge margin of the scanned image for the corrected image Amount of Change per:0.1mm
FEEDER > ADJUST > ADJ-T1 (front side)
FEEDER > ADJUST > ADJ-T2 (back side)
• Adjustment of the left edge margin of the scanned image for the corrected image Amount of Change per:0.1mm
FEEDER > ADJUST > ADJ-L1 (front side)
FEEDER > ADJUST > ADJ-L2 (back side)
• Angle correction of the corrected image Amount of Change per:0.01 degree
FEEDER > ADJUST > ADJ-ROT1 (front side)
FEEDER > ADJUST > ADJ-ROT2 (back side)
• Parallelogram correction amount for corrected image Amount of Change per:0.01 degree
FEEDER > ADJUST > ADJ-PAR1 (front side)
FEEDER > ADJUST > ADJ-PAR2 (back side)
Refer to the following Service Manual
• Adjustment > Original Feed System (Single Pass ADF) > Skew Adjustment (at Stream Scanning of Originals)
● Creating the Test Charts for Image Position Adjustment
CAUTION:
Create the test charts for image position adjustment after completing adjustments on the printer side.
1. After setting the service modes as follows, press the Start key to output the test chart.
• COPIER > TEST > PG > TYPE = 6
• COPIER > TEST > PG > PG-PICK = To set the Pickup Cassette for test print output.
NOTE:
• If the specified test chart cannot be output, draw a test chart on A3 or LDR paper with a rectangle whose four corners are 10
mm smaller than the paper.
• To draw characters and marks so that you can see the direction of the copied image.
10 mm
10 mm
10 mm
131
10 mm
2. Host Machine
Advertisement
Table of Contents
