Table of Contents
Advertisement
8.
■ Setting the Mirroring
1. Set the setting value for the mirroring to "1" in the following service mode.
COPIER > OPTION > FNC-SW > W/RAID
2. Turn OFF/ON the main power of the host machine to enable the setting value.
3. Make sure that the UI screen is activated correctly.
4. Open the Cover, and make sure that the LED blinks.
NOTE:
Rebuilding starts approximately after 60 seconds after turning OFF and then ON the power.
• SSD 1 (Slot 1): The green LED blinks.
• SSD 2 (Slot 2): The green and red LEDs blink.
16x
299
4. Host Machine Options
Advertisement
Table of Contents
