Table of Contents
Advertisement
Staple Finisher-AG1/Booklet Finisher-AG1
Checking before Installation
■ Checking the Power Supply
1. The equipment must be connectable to the outlet that can supply the rated voltage +10/-15% at the specified ampere or
higher.
2. When connecting the power plug of this equipment to an outlet, be sure to use an outlet of a system different from that of
the host machine.
3. Install this equipment near the power outlet and leave sufficient space around the power plug so that it can be unplugged
easily in an emergency.
■ Checking Before Installation
CAUTION:
• When installing this equipment to the Puncher Unit, be sure to do so before connecting it to the host machine.
• Be sure to install this equipment after installing the Accessory Interface Kit-A2 and Buffer Pass Unit.
• The label shown below is attached to locations where connection of a network cable is prohibited.
Do not connect the customer's network cable to the port where the connection prohibition label is affixed.
■ Points to Note on Installation
• This equipment machine weighs Staple Finisher: approx. 130kg, Booklet Finisher: approx. 180kg. It is recommended to lift
it with 4 people or more. However, if there is a standard to handle a heavy load in each sales company, follow it for operation.
Also, make sure to lift the machine with keeping it level at operation.
• When moving this equipment after having unpacked it, be careful by placing a plate, etc. on areas with steps to prevent the
casters from hitting those steps. If the casters hit a step, the casters or the base plate may be deformed.
■ Checking the Unpacking Space
The dimensions shown in the figure below are the minimum space required.
Thus it is desirable to secure more space for the work than shown in the figure below.
675
6. Paper Output Options
Advertisement
Table of Contents
