Canon imagePRESS Lite C270 Installation Manual page 768

5. If the value obtained at "Checking Adjustment Value" is "+ (positive)", move it in [A] direction and tighten the 2
screws.
If the value obtained at "Checking Adjustment Value" is "- (negative)", move it in [B] direction and tighten the 2 screws.
CAUTION:
Perform adjustment so that the total of the shifting amount (scale) of the Latch Plate (Front/Rear) is within -2 to +2 mm.
6. Remove the Rear Small Cover.
• 1 Screw
7. Loosen the 2 screws on the Latch Plate (Rear).
Screw
1x
759
6. Paper Output Options
2x
2x
[A] [B]