Canon imagePRESS Lite C270 Installation Manual page 102

9. Install the Handle Cover.
NOTE:
If you are concerned with alignment of the Right Deck Cover, perform the following steps to adjust the position of the Right Deck
Cover as necessary.
1. Loosen the 5 screws, and adjust the position of the Right Deck Cover using the scale as reference.
2. Tighten the 5 screws you loosened.
< Adjustment of the Left Deck >
1. Measure the left margin of the image.
Check that the measured value is within the specified range shown below. When the result is out of the specified range,
perform adjustment by following the following procedure.
• Standard Values : L4 = 2.5 +/- 1.5 mm
1x
2x
L4
93
2x
2. Host Machine