Table of Contents
Advertisement
■ Adjusting the Deck Cover Gap
NOTE:
When the Lock Bracket is adjusted, perform the gap adjustment for the Deck Cover.
1. Close the deck and check that the values of the gap [A] and [B] are within specification. In the case of out of
specification, perform the gap adjustment for the Deck Cover as the following procedures.
• Specification value for the gap [A]: 3.0 -/+ 1.5 mm (the gap on the side of the Deck Front Cover)
• Specification value of the alignment [B]: -/+ 1.5 mm (the alignment between the Deck Upper Left Cover and the Deck
Cover)
2. For the reference at adjustment, remember the scale marked around the mounting Screw of the Deck Cover.
[B]
[A]
463
5. Paper Feed Options
Advertisement
Table of Contents
