Table of Contents
Advertisement
3. Inform the system administrator at the installation site that the installation of the machine has been completed, and
ask to specify the network settings.
NOTE:
Network settings can be made only when logged in as an administrator.
The default password is indicated below.
• System Manager ID: Administrator
• System PIN: 7654321
CAUTION:
To specify the network settings, it is required to turn ON the following Initial Settings/Registration items.
• [Settings/Registration] > [Preferences] > [Network] > [Confirm Network Connection Set. Changes.]
• [Settings/Registration] > [Preferences] > [Network] > [TCP/IP Settings] > [IPv4 Settings] > [Use IPv4]
4. Turn OFF and then ON the main power switch.
■ Using the Ping Command
1. Select [Settings/Registration] > [Preferences] > [Network] > [TCP/IP Settings] > [IPv4 Settings] > [PING command].
2. Enter the IP address using the Control Panel Numeric Keypad, and press "Start" key.
• When Ping succeeded, "Response from the host." is displayed.
• When Ping failed, "No response from the host." is displayed.
■ Checking by the Remote Host Address
Using the remote host address to execute Ping can check whether connection to the network is enabled or not.
Remote host address: IP address of PC terminal connected/running on TCP/IP network environment that connects to
this equipment.
1. Inform the system administrator about checking of the network connection using Ping.
2. Confirm the remote host address with the system administrator.
3. Enter the remote host address to Ping.
• The network is properly connected if the message say "Response from the host".
• The network is not properly connected if the message say "No response from the host", therefore, execute the following
troubleshooting.
Network Troubleshooting
■ Checking Connection of the Network Cable
To check whether the network cable is properly connected to the LAN Port.
■ Operation Procedure Using Ping
1. Ask the network administrator at the user's site to write down the IP address of the PC that is connected to the
network.
2. [Settings/Registration] > [Preferences] > [Network] > [TCP/IP Settings] > [IPv4 settings] > [Ping Command]; and
enter the IP address of the PC with the numeric keypad and press Execute key.
• The network is properly connected if the message say "Response from the host".
• If the message say "No response from the host", check the following.
141
2. Host Machine
Advertisement
Table of Contents
