Imagepress Server M20; The Ip Addresses For Communication Between The Host Machine And Equipment Are Set Automatically; Check When Connecting The Power Plug To An Outlet; Checking The Contents - Canon imagePRESS Lite C270 Installation Manual

imagePRESS Server M20

The IP addresses for communication between the host machine and
equipment are set automatically
1. Turn ON the main power switch of the host machine.
2. Set the value in the following service mode to "3".
COPIER > OPTION >INT-FACE > IMG-CONT
3. Exit from Service Mode.
4. Turn OFF the main power switch of the host machine.

Check When Connecting the Power Plug to an Outlet

1. When connecting the power plug of this equipment to an outlet, be sure to use an outlet of a system different from that of
the host machine.
2. Be sure to install this equipment near an outlet so that the power plug can be disconnected right away in case of emergency,
and do not put anything around the power plug.

Checking the Contents

1x
Stepped Screw;
M4x9
2x
* Power Cord: The connector has a different shape depending on locations. 2 are packaged in the products for EUR/1 is packaged
in the products for USA. Use the correct power cord to mach the location/area of installation.
Make sure not to leave unused power cord at the site.
<Others>
• Including guides
1x
1x 1x
Stepped Screw; Toothed Washer Screw
M3x9.6 (Binding; M4x8)
2x
1x
2x
TP; M3x8
4x
4x
301
4. Host Machine Options
1x
2x
9.7 mm
1x
2x
TP; M3x6
Toothed Washer
2x 4x