Material Flush/Fill Wizard - Stratasys Objet24 User Manual

Material
Flush/Fill
Wizard
DOC-34014 Rev. C
After these tasks are completed, the final wizard screen appears, in
which you choose whether or not to shut down the computer in the
Objet printer at this time.
Figure 6-15: Computer Shutdown confirmation screen
5. When completely shutting down the Objet printer and turning the
power off, select
Yes
6. After the printer computer shuts down, turn off the main power switch
at the back of the printer (see figure 6‐2 on page 2).
Using the Material Flush/Fill wizard before and after an extended period of
inactivity (more than one week) ensures proper printer maintenance and
quality printing. Each time you run the wizard, you select one of the
following processes:
•
draining printing materials and flushing the system with cleaning fluid
Use this process to prepare the printer for a shutdown of more than one
week. This process takes about 60 minutes, and requires four (4)
cleaning‐fluid cartridges in the materials drawer.
•
filling the system with fresh printing materials
Use this process to restore the printer to working condition. This process
takes about 30 minutes, and requires two (2) cartridges of Model
material and two (2) cartridges of Support material in the materials
drawer.
After more than one week of inactivity, drain and flush the system if this was
not previously done. In this case, run the wizard twice before printing—first,
to drain old printing material and clean the system, and again, to fill it with
fresh material.
To run the Material Flush/Fill wizard:
1. Start

Material Flush/Fill wizard

2. In the opening screen, click
and click .
Next
from the Options menu.
.
Next
Objet24 User Guide
6–15