Remove The Server From The Rack; Access Panel Options; Open The Access Panel To Access Drive Cage 3 - HPE Apollo 4200 Gen10 Plus Maintenance And Service Manual

to the rails. Hewlett Packard Enterprise recommends that a minimum of two people are required for all rack server
installations. A third person may be required to help align the server if the server is installed higher than chest
level.
Use caution when installing the server in or removing the server from the rack; it is unstable when not fastened to
the rails.
WARNING: WARNING:
To reduce the risk of personal injury or damage to the equipment, be sure that:
The rack is bolted to the floor using the concrete anchor kit.
The leveling feet extend to the floor.
The full weight of the rack rests on the leveling feet.
The racks are coupled together in multiple rack installations.
Only one component is extended at a time. If more than one component is extended, a rack might become unstable.
Procedure Procedure
1. Back up all server data.
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.

5. Remove the server from the rack.

6. Place the server on a flat, level surface.

Access panel options

Access panel options

Open the access panel to access drive cage 3

Open the access panel to access
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server in CAUTION:
this manner results in improper airflow and improper cooling that can lead to thermal damage.
Procedure Procedure
1. Extend the server from the rack .
2. Remove the access panel:
a. If necessary, unlock the access panel latch.
b. Press the release button.
c. Pull up the latch to disengage the access panel from the chassis.
d. Lift the front half of the access panel to access drive cage 3.
drive cage 3
HPE Apollo 4200 Gen10 Plus Server Maintenance and Service Guide 21