Preparation Procedures; Power Up The Server - HPE ProLiant DL365 Gen11 Maintenance And Service Manual

This symbol indicates the presence of moving parts inside the product that may present a pinch point if improperly contacted.
WARNING: WARNING:
Hazardous moving parts. Do not insert any tools or any part of your body into the product while it is operating or in
any openings.

Preparation procedures

Preparation procedures
To access some components and perform certain service procedures, you must perform one or more of the following procedures:
Extend the server from the rack .
If you are performing service procedures in a Hewlett Packard Enterprise, Compaq branded, Telco, or third-party rack cabinet, you can
use the locking feature of the rack rails to support the server and gain access to internal components.
For more information about Telco rack solutions, refer to the RackSolutions.com website
Power down the server.
If you must remove a server from a rack or a non-hot-plug component from a server, power down the server.
Remove the server from the rack .
If the rack environment, cabling configuration, or the server location in the rack creates awkward conditions, remove the server from the
rack.
Subtopics Subtopics

Power up the server

Power up the server
Power down the server Power down the server
Extend the server from the rack Extend the server from the rack
Remove the server from the rack Remove the server from the rack
Remove the access panel Remove the access panel
Install the access panel Install the access panel
Releasing the cable management arm Releasing the cable management arm
Power up the server Power up the server
About this task About this task
To power up the server, use one of the following methods:
Press the Power On/Standby button.
Use the virtual power button through iLO.
RackSolutions.com website.
HPE ProLiant DL365 Gen11 Server Maintenance and Service Guide 32