Installing The Optional Dat Tape Drive - Sun Microsystems Sun Fire V1280 Site Preparation And Installation Manual

B
A P P E N D I X
Installing the Optional DAT Tape
Drive
Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing them on any surface.
Caution – This procedure requires the system to be extended out of the rack on its
slides. Before attempting this procedure you must deploy rack stabilization devices,
if fitted.
1. If necessary, power down the system and remove the input power connectors.
Refer to "Using the Power (On/Standby) Switch" on page 82.
2. Deploy the rack stabilization device, if fitted.
3. Extend the system from the rack.
Loosen the captive screws securing the system to the rack and gently pull it out on
its slides.
4. Open the right-hand front door of the system.
5. Attach a wrist strap or foot strap to one of the grounding attachment points.
These are located on each side of the chassis..
6. Open the media bay cover.
Loosen the latch securing screw, lift the latch and raise the cover. Refer to .
FIGURE B-1
69