Installing Or Removing Hot-Pluggable Hard Disk Drives; Figure 4-1 Inserting Hard Disks Into The Drive Bays - Sun Microsystems Netra t1 100 User And Administration Manual

Installing or Removing Hot-Pluggable
Hard Disk Drives
The hard disk drives are hot-pluggable modules. You do not need to power down
the system or remove it from the rack to install or remove hard disk drives.
1. Remove the front bezel by pressing the latch at either end.
FIGURE 4-1
2. Lever out the grilles.
3. If you are:
Installing hard disk drives, slide the disk drive(s) into their trays in the front of
the system (see
backplane connector.
Removing hard disk drives, lift the ejector latch (see
each disk drive you are removing and pull the drive out.
4. Replace the grilles and front bezel.
22 Netra t1 User and Administration Guide • June 2000
Drive 0
1
Inserting Hard Disks into the Drive Bays
). Press them firmly to ensure they are engaged with the
FIGURE 4-1
3
Drive 1
2
) at the front of
FIGURE 4-1