Initial Sun Storagetek 5320 Nas Cluster Appliance Configuration; To Set Ip Addresses - Sun Microsystems StorageTek 5320 Getting Started Manual

Initial Sun StorageTek 5320 NAS Cluster
Appliance Configuration
Note – These instructions apply to the Sun StorageTek 5320 NAS Cluster Appliance
only. For Sun StorageTek 5320 NAS Appliance configuration instructions, refer to
Chapter 3. For Sun StorageTek 5320 NAS Gateway System and NAS Gateway
Cluster System configuration instructions, refer to
To complete the initial Sun StorageTek 5320 NAS Cluster Appliance configuration,
you must specify the following:
IP addresses
■
Basic configuration information
■
Failover configuration information
■
LUN ownership
■
LUN paths
■

To Set IP Addresses

▼
You assign a static IP address using the server H1's LCD panel:
1. Select Menu.
2. Select A. Network Config.
3. Select A. Set Gateway and enter the gateway address.
4. Select C. Set Port-emc2 and enter the IP address, subnet mask, and broadcast
address as prompted.
This IP address information is assigned to the first regular (non-heartbeat) LAN
port, emc2, on your system.
Caution – Do not change the private IP address on the network port that is used for
the HB Port (heartbeat port).
5. Select Escape twice to return to the main menu.
Chapter 4 Installing the Sun StorageTek 5320 NAS Cluster Appliance
Chapter 5.
93