7.3.8
Set Security
The security option allows you to prevent a user from inadvertently changing
important settings and operations.
Note – Security remains in effect after resetting the tape library.
When security is enabled, a user cannot access the following activities:
Changing the control mode
Changing the SCSI IDs
Changing the library serial number
Changing SCSI parity checking
Using the Diagnostics Menu and the Demo Menu
Using the Clean Drives Menu
Opening the front door (LCD security only)
If a user attempts to perform any of the these operations when security is enabled,
the tape library displays a message stating security is active.
To enable or disable security:
1. Select the Configuration Menu by pressing
2. Select Set Security On/Off by pressing
3. Select a three digit password.
To disable security, enter the same password used to turn security on.
a. Move from column to column by pressing
b. Change the password (default password is 000) by pressing
c. Press Enter to make the password active.
Note – If you forgot the password, enter the default password, 000.
7.3.9
Set Serial Number
A label on the back of the unit displays the serial number. To enter the serial number
in the tape library firmware, use the Set Serial Number option.
1. Select the Configuration Menu by pressing
2. Select Set Serial Number by pressing
↓
↑
or
, then Enter.
↓
↑
or
, then Enter.
←
→
or
.
↓
↑
or
, then Enter.
↓
↑
or
, then Enter.
Chapter 7
Tape Library Menu Functions
↑
↓
or
.
7-11