10
C H A P T E R
Board Set Carrier Plates
The board set carrier plates inside the Sun Fire E25K/E20K systems require special
handling. There are also three different configuration setups depending on the board
sets the carrier plate is assigned to carry. For increased thermal control, a carrier
plate with an air dam has been designed for slots 4, 5, 13, and 14. This chapter
contains the replacement procedures for these three configurations.
This chapter contains the following sections:
Section 10.1, "Inserting a Board Set Carrier Plate" on page 10-2
I
Section 10.2, "Carrier Plate Configuration Modification and Replacement" on
I
page 10-5
I
I
I
I
For your protection, also observe the following safety precautions when setting up
your equipment:
Follow all cautions and instructions marked on the equipment.
I
Always use proper ESD equipment and procedures when handling boards and
I
components.
Never push objects of any kind through openings in the equipment as they might
I
touch dangerous voltage points or short out components that can result in fire or
electric shock.
Refer servicing of equipment to qualified personnel.
I
Section 10.2.1, "Two-In-One Carrier Plate FRU Modification Contents" on
page 10-6
Section 10.2.2, "Carrier Plate Replacement for Standard Configuration of
Slots 1, 2, 3, 6, 7, 8, 10, 11, 12, 15, 16, and 17" on page 10-6
Section 10.2.3, "Carrier Plate Configuration and Replacement for Slots 0 and 9"
on page 10-7
Section 10.2.4, "Carrier Plate Replacement for Standard Configurations of
Slots 4, 5, 13, and 14" on page 10-8
10-1