Table of Contents
Advertisement
D.2.1
Not Ready—Sense Key 2h
During a Not Ready condition, the tape library returns a Check Condition status in
response to each motion command until the Not Ready condition is removed.
During this time, the sense key is set to Not Ready and the ASC and ASCQ are set to
codes specifying that the tape library is not ready. All commands except tape motion
commands, perform normally.
TABLE D-3
TABLE D-3
ASC
Byte 12
04h
D.2.2
Hardware Error—Sense Key 4h
The tape library returns a sense key of Hardware Error (4h) when a hardware-
related error occurs. After Hardware Error occurs, the tape library will not accept
motion commands. For each additional motion command, the tape library returns
the same Hardware Error. The tape library executes all other commands normally.
TABLE D-4
for the display panel numbers, see
lists Not Ready sense key (2h) error conditions.
Not Ready Sense Key (2h) ASC and ASCQ Values
ASCQ
Description
Byte 13
01h
The tape library is performing an initialization after a reset or the door
was closed.
83h
The front door is open.
84h
The tape library is executing ROM boot code and cannot execute the
command
89h
The tape library is in 25-pin, 9-pin, or 4-pin serial port mode.
8Dh
The tape library is in LCD Interface mode.
8Eh
The tape library is in Sequential CTS1, Sequential CTS2, or Dual
Sequential modes.
lists Hardware Error (4h) conditions. To determine the corrective actions
.
TABLE D-1
Appendix D
Error Codes
D-9
Advertisement
Table of Contents
