3
C H A P T E R
Maintaining a StorageTek Array
This chapter contains the procedures about how to maintain a StorageTek array. These procedures
are specific to a Sun
This chapter contains the following procedures:
I
"How to Upgrade Storage Array Firmware" on page 24
I
"How to Remove a Storage Array" on page 25
I
"Replacing a Node-to-Switch Component" on page 26
"How to Replace a Host Adapter" on page 27
I
"How to Replace a Disk Drive" on page 29
I
For detailed information about storage array architecture, features, and configuration utilities, see
the StorageTek documentation listed in
FRUs That Do Not Require Sun Cluster Maintenance
Procedures
In general, the following is a list of administrative tasks that require no cluster-specific procedures.
See the base-product documentation for these procedures.
Note –
FRUs might require cluster-specific steps. Such FRUs include the DSP and service processor panel.
I
I
I
I
I
I
I
3
TM
Cluster environment.
Depending on your configuration type and the state of your cluster, a few of the following
Adding a disk drive.
Replacing a storage array's chassis.
Replacing an Ethernet cable.
Replacing a power supply.
Replacing the power cable on the storage array.
Replacing a power and cooling unit (PCU).
Replacing a controller.
"Related Documentation" on page
6.
23