Table of Contents
Advertisement
2.3.2
Adding the Bar Code Labels
Center the label within the area on the edge of the cartridge (
Bar code labels on your 8 mm cartridges are used by the bar code scanner to gather
information.
FIGURE 2-5
2.3.3
Placing the Tape Cartridge in the Removable
Holder
1. Make sure the write-protect switch is write enabled (switch is to the right) on the
tape cartridges.
2. Using the holder's single mounting guide for orientation, insert a cartridge into
the holder (
Very little force is needed to install a cartridge into the cartridge holder. If the
cartridge does not snap into place easily, check the orientation of the cartridge.
Placing Bar Code Labels
).
FIGURE 2-6
Chapter 2
FIGURE 2-5
Preparing the Tape Library for Installation
).
2-7
Advertisement
Table of Contents
