M How To Install A Storage Array In A New Cluster Using A Single-Controller Configuration; Adding Arrays To An Existing Cluster, Using A; Partner-Group Configuration - Sun Microsystems StorEdge T3+ Manual

TABLE 1-1
Task
Installing arrays in a new cluster, using a partner-group
configuration
Adding arrays to an existing cluster, using a
single-controller configuration.

Adding arrays to an existing cluster, using a

partner-group configuration.
Upgrading a T3 storage array to a T3+ array.
Migrating a single-controller array configuration to a
partner-group configuration.
M
How to Install a Storage Array in a New Cluster
Using a Single-Controller Configuration
Use this procedure to install and configure the first storage array in a new cluster,
using a single-controller configuration. Perform the steps in this procedure in
conjunction with the procedures in the Sun Cluster software installation
documentation and your server hardware manual.
The following procedures contain instructions for other array-installation situations:
"How to Install a Storage Array in a New Cluster, Using a Partner-Group
I
Configuration" on page 16
I "How to Add a Storage Array to an Existing Cluster, Using a Single-Controller
Configuration" on page 20
"How to Add a Storage Array to an Existing Cluster, Using a Partner-Group
I
Configuration" on page 29
12 Sun Cluster 3.0-3.1 With Sun StorEdge T3 or T3+ Array Manual for Solaris OS • January 2006, Revision A
Task Map: Installing a Storage Array (Continued)
Information
"How to Install a Storage Array in a
New Cluster, Using a Partner-Group
Configuration" on page 16
"How to Add a Storage Array to an
Existing Cluster, Using a
Single-Controller Configuration"
on page 20
"How to Add a Storage Array to an
Existing Cluster, Using a
Partner-Group Configuration"
on page 29
"How to Upgrade a StorEdge T3
Controller to a StorEdge T3+
Controller" on page 65
"How to Migrate From a
Single-Controller Configuration to a
Partner-Group Configuration"
on page 66