Installing Storage Arrays
Node 1
FIGURE 2–1
FIGURE 2–2
How to Install Storage Arrays in a New Cluster
Use this procedure to install a storage array in a new cluster. To add a storage array to an existing
cluster, use the procedure in
This procedure relies on the following assumptions:
I
You have not installed the Solaris Operating System.
You have not installed the Sun Cluster software.
I
Your cluster has not been established.
I
You have enough host adapters to connect the nodes and the storage array to the service
I
processor panel.
14
Sun Cluster 3.0-3.1 With Sun StorEdge 6130 Array Manual • June 2006, Revision A
Node 2
SPARC: Sun StorEdge 6130 Array Direct-Connect Configuration
Node 1
Node 2
Switch
Switch
Switched Configuration
"How to Add Storage Arrays to an Existing Cluster" on page
Controller module
Controller module
Expansion tray
16.