Table of Contents
Advertisement
To Install the System With a Single Controller
▼
Enclosure
1. Mount the controller enclosure in the bottom of the cabinet.
2. Mount any expansion enclosures (maximum six) from the bottom up.
The first expansion enclosure above the controller enclosure is EU 1, then EU 2, and
so on.
3. Mount the Sun StorageTek 5320 NAS Appliance in the top of the cabinet.
If you are installing a cluster, install the servers as follows:
a. Sun StorageTek 5320 NAS Appliance server H1 (software serial number ending
"-H1") at the top.
The software serial number is located at the front of the server, below the LCD
display. It is also printed on the Customer Information Sheet (CIS).
b. Sun StorageTek 5320 NAS Appliance server H2 (software serial number ending
"-H2") below server H1.
To Install the System With Two Controller
▼
Enclosures
1. Mount the controller enclosure in the bottom of the cabinet.
2. Mount any expansion enclosures (maximum four) from the bottom up, and be
sure to leave space for the maximum four EUs if you do not install them at this
time.
The first expansion enclosure above the controller enclosure is EU 1, then EU 2, and
so on.
3. Mount the second controller enclosure.
4. Mount any expansion enclosures (maximum four) for the second controller
enclosure, and be sure to leave space for the maximum four expansion enclosures
if you do not install them at this time.
5. Mount the Sun StorageTek 5320 NAS Appliance in the top of the cabinet.
If you are installing a cluster, install the servers as follows:
a. Sun StorageTek 5320 NAS Appliance server H1 (software serial number ending
"-H1") at the top.
The software serial number is located at the front of the server, below the LCD
display. It is also printed on the Customer Information Sheet (CIS).
20
Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
Advertisement
Table of Contents
