General Safety Instructions - OnRobot VGC10 User Manual

Safety

2.2 General Safety Instructions

Generally, all national regulations, legislations and laws in the country of installation must be o bserved.
Integration and use of the product must be done in compliance with precautions in this manual. Particular
attention must be paid to the following warnings:
DANGER:
You must read, understand, and follow all safety information in this
manual, and the robot manual and all associated equipment before
initiating robot motion. Failure to comply with safety information could
result in death or serious injury.
The information in this manual does not cover designing, installing, and
operating a complete robot application, nor does it cover other
peripheral equipment that can influence the safety of the complete
system. The complete system must be designed and installed in
accordance with the safety requirements set forth in the standards and
regulations of the country where the robot is installed.
Any safety information provided in this manual must not be construed as
a warranty, by OnRobot A/S, that the robot application will not cause
injury or damage, even if robot application complies with all safety
instructions.
OnRobot A/S disclaims any and all liability if any of OnRobot tools tooling
are damaged, changed or modified in any way. OnRobot A/S cannot be
held responsible for any damages caused to any of OnRobot tools tooling,
the robot, or any other equipment due to programming errors or
malfunctioning of any of OnRobot tools.
WARNING:
OnRobot tools are not allowed to be exposed to condensing conditions
when power is on or when connected to a robot. If condensing conditions
appear during transport or storage, the product must be placed between
20 and 40 Celsius degrees for 24 hours before power is applied or before
connected to a robot.
It is recommended that OnRobot tools are integrated in compliance with the following guides and
standards:
• ISO 10218-2
• ISO 12100
• ISO/TR 20218-1
• ISO/TS 15066
7