Instructions
– Disconnect the ribbon cable from the main board, whilst
leaving it connected to the P700 Carrier Board Assembly
– Remove screws on P700 Carrier Board Assembly using T8
Torx screwdriver bit with 5Ibs-in.
– Remove the P700 Carrier Board Assembly.
Remove 4 screws 0515-1940 using bit T8 torque driver with
5lbs-in to remove P700 IO module board from P700 carrier
board.
Keysight N1913B/N1914B EPM Series Power Meters Service Guide
Visual
Figure 6-12
Remove P700 Carrier Board
Assembly
Figure 6-13
Remove P700 IO module board
from P700 Carrier Board
Repair Guide
6
111