VESPA 946 E4 EMEA 2021 Manual page 54

Maintenance
During refitting of the central cover, ensure the correct position of the rubber protection. Refer to para-
graph "Battery compartment - Inverter" in the "Bodywork" chapter.
Hub oil
Check
Check oil level with the vehicle placed on the cen-
tre stand and on a flat surface.
Undo the indicated screw and check for oil by in-
serting a shank/plug. The level should be just un-
der the lower margin of the fill hole.
In case of oil leakage, carefully clean the trans-
mission crankcase with a cloth.
CAUTION
REPLACE THE COPPER GASKET EACH TIME THE LEVEL
CHECK AND/OR HUB OIL DRAINAGE SCREW IS UN-
SCREWED.
Replacement
Remove the hub oil level check screw.
Prepare an adequately sized container under the
crankcase at the height of the wheel hub.
Unscrew the oil drainage screw and drain out all
the oil.
Tighten the oil drain screw to the prescribed torque.
CAUTION
REPLACE THE COPPER GASKET EACH TIME THE LEVEL CHECK AND/OR HUB OIL DRAINAGE
SCREW IS UNSCREWED.
MAIN - 54
Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)