Braking system
3.5 MM
Max. deviation allowed:
0.1 mm
Front brake disc
Removal
- Remove the front wheel hub.
- Undo the screws indicated.
Refitting
- Carry out the removal steps but in the reverse order, paying attention to the prescribed torques.
- Check the gap between tone wheel and front speed sensor.
Locking torques (N*m)
brake disc screws 8 - 10
Disc Inspection
- Remove the rear wheel.
- Use a calliper to check the disc thickness as
shown in the photograph.
- Repeat the measurement at no fewer than six
points on the disc.
BRAK SYS - 244
Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)