VESPA 946 E4 EMEA 2021 Manual page 233

Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)
MODULATOR REMOVAL
- Remove the right side fairing and the left side
fairing.
- Disconnect the connector of the ABS control unit.
- Undo the screws fixing the control unit to the
bracket.
- Unscrew the screw «A» and the nuts «B» fixing
the bracket of the control unit to the body.
- Unscrew the nuts, remove and close the brake
oil tubes in sequence (1) - (2) - (4) - (3).
N.B.
PAY ATTENTION TO THE LOSS OF BRAKE FLUID DURING
THE REMOVAL OF THE PIPING FROM THE MODULATOR.
USE A SMALL CONTAINER AND A CLOTH.
MODULATOR INSTALLATION
When installing the ABS modulator, repeat the operations described in the removal in reverse order,
paying close attention when inserting the pipes.
Before installing the side fairings, bleed the brake system in order to restore the correct operation of
the braking system.
Braking system
BRAK SYS - 233