VESPA 946 E4 EMEA 2021 Manual page 86

Electrical system
B = Speedometer
C = Multifunction indicator
D = ASR Icon
E = High-beam warning light
F = MIL warning light - Injection system failure warning light
G = Immobilizer warning LED
H = ABS warning light
I = Low engine oil pressure warning light
L = Turn indicator warning light
M = Miniature «VESPA 946»
By turning the ignition key to the «ON» position all the digital display functions will light up for a few
seconds.
MULTIFUNCTION INDICATOR «C»
Acting on the MODE button this indicator displays the following functions in sequence:
- Clock (CLOCK)
- Total odometer (ODO)
- Partial odometer (TRIP)
For this indicator «C» and for the speed indicator «B» the unit of measurement can be changed (from
Km to Miles and from Kph to mph) with the following procedure:
- move the key to «OFF»;
- press the MODE button to the left;
- Holding in the MODE button, turn the key to the «ON» position;
- after about 2 seconds release the MODE button.
WARNING
TO SWITCH FROM km/h TO mph, THE MULTIFUNCTION INDICATOR "C" MUST BE SET TO TO-
TAL ODOMETER (ODO).
N.B.
THE FOLLOWING ARE DEFINED WHEN NAVIGATING THE DISPLAY:
- «BRIEF PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF LESS THAN TWO
SECONDS;
- «PROLONGED PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF MORE
THAN TWO SECONDS.
N.B.
THE VEHICLE IS EQUIPPED WITH A DEVICE ABLE TO
PRESERVE THE FUNCTIONALITY OF THE LIGHT ASSEM-
BLY IN CASE OF OVERHEATING.
THIS SYSTEM CONSISTS OF A SOFTWARE INTEGRATED
IN THE ENGINE ECU THAT RECEIVES SIGNALS FROM
THE DASHBOARD AND ADJUSTS THE LIGHT POWER
WHEN THE HEADLAMP'S TEMPERATURE IS TOO HIGH.
THIS MAY HAPPEN WHEN A PIECE OF CLOTHING OR A
FABRIC IS PLACED ON THE HEADLAMP OR ON THE HAN-
DLEBAR FOR A FEW MINUTES WHILE THE ENGINE IS
STATIONARY AND RUNNING AT IDLE.
WHEN THE FIRST TEMPERATURE THRESHOLD IS
REACHED, THE DISPLAY SHOWS AN "Alert" - "Light" AL-
TERNATING CYCLIC MESSAGE.
ELE SYS - 86
Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)