VESPA 946 E4 EMEA 2021 Manual page 16

Pre-delivery
- Total odometer (ODO)
- Partial odometer (TRIP)
For this indicator «C» and for the speed indicator «B» the unit of measurement can be changed (from
Km to Miles and from Kph to mph) with the following procedure:
- move the key to «OFF»;
- press the MODE button to the left;
- Holding in the MODE button, turn the key to the «ON» position;
- after about 2 seconds release the MODE button.
WARNING
TO SWITCH FROM km/h TO mph, THE MULTIFUNCTION INDICATOR "C" MUST BE SET TO TO-
TAL ODOMETER (ODO).
N.B.
THE FOLLOWING ARE DEFINED WHEN NAVIGATING THE DISPLAY:
- «BRIEF PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF LESS THAN TWO
SECONDS;
- «PROLONGED PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF MORE
THAN TWO SECONDS.
CLOCK SETTING
To set or adjust the clock, with the vehicle running
or with key inserted in "ON" position, proceed as
follows:
- short press the MODE button to the left in se-
quence until the clock appears on the display;
- long press to the left to enter the hour display;
- adjust the hour by short pressing the MODE but-
ton to the left;
- with a long press, the set value is confirmed (or
present value if not modified) and it goes on to the
minutes display
- adjust the minutes by short pressing the MODE
button to the left;
- after a few seconds the set or changed time will
be displayed.
WARNING
FOR SAFETY REASONS THE TIME SETTING IS ONLY
POSSIBLE WITH THE VEHICLE AT A STANDSTILL.
WARNING
DETACHING THE BATTERY CABLES IMPLIES RESET-
TING THE CLOCK, WHICH WILL SHOW «12:00» UNTIL IT
IS ADJUSTED AGAIN, AND RESETTING OF THE TRIP OD-
OMETER.
PRE DE - 16
Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)