Vespa 946 E4-E5 EMEA-USA-ASIA (2021-)
• In case of failure to complete the procedure within 2 minutes the ASR icon «2» will stay on steady and
the ASR will remain off until the panel is turned off (key off).
• To restart the ASR it is necessary to turn on vehicle panel (key on).
It is however necessary to repeat the process until it succeeds.
Rear brake calliper
Removal
- Remove the complete silencer.
- Remove the rear wheel.
- Remove the two screws indicated
N.B.
IF IT IS NECESSARY TO REPLACE OR SERVICE THE
BRAKE CALLIPER, BEFORE REMOVING THE FITTINGS
FIXING THE CALLIPER TO THE SUPPORT BRACKET,
FIRST LOOSEN THE OIL HOSE FITTING AFTER HAVING
EMPTIED THE SYSTEM OF THE CIRCUIT BEING EXAM-
INED.
Refitting
- Follow the removal procedures but in reverse order and tighten to the prescribed torques with the
recommended product.
Locking torques (N*m)
Rear brake calliper fixing screws 20 - 25
- If the calliper was replaced, bleed the system.
CAUTION
ONCE REFITTING IS FINISHED, BLEED THE SYSTEM.
CAUTION
ALWAYS USE NEW COPPER WASHERS.
Locking torques (N*m)
Rear brake calliper-pipe fitting 20 - 25
Front brake calliper
Braking system
BRAK SYS - 239