Table of Contents
Advertisement
To use the quick measurements
The action taken when this key is pressed depends on the feature that is
selected in the Customize Multipurpose dialog box. The default feature is
QuickMeas (quick measurements) which is described as follows.
• To turn on the quick measurement display, press the Multipurpose key.
The five preset measurements defined in the Quick Measurement configuration
are enabled and results are displayed on the screen for the first waveform
source. The default measurements are: V
Fall time.
• To measure parameters for another waveform, press the Multipurpose
key until that waveform is the one shown in the measurement readout.
Continuing to press the Multipurpose key cycles through each of the waveforms
available.
• To turn off the quick measurement display, press and release the
Multipurpose key until the measurements are turned off.
The measurement results disappear from the screen.
See the built-in information system (described in Chapter 4) for information on
how to configure the quick measurement capability, using the Customize
Measurement feature of the graphical interface.
Figure 3-10
Quick Measurement Key
, Period, Frequency, Rise time, and
p-p
Press this key to turn
Quick Measurements
on or off
Using the Oscilloscope
To use the quick measurements
3-17
Advertisement
Table of Contents
